Author Topic: Clay's vs Claydot  (Read 2696 times)

Nawlins Kid

  • WBAS Committee & Ambassadors
  • Full Member
  • *******
  • Posts: 155
Clay's vs Claydot
« on: November 20, 2015, 05:11:34 AM »
Recently I was able to purchase a 8 lb container of Claydot. I normally use Clays but I was getting low on powder. Yesterday the temp was around 60 degs. overcast with occasional sprinkling of rain, an anomaly here in Western NY in Nov.

My Crony digital is 10 + years old so results may be different with a newer models. I used Remington primers and mixed brass.

I normally use 3.7 grains of Clay's and 230 gr. bullet which produces around an average of 751 FPS.  This come out to 172 PF 

The same load with Claydot produced an average of  737 FPS which is a 169 PF

The next load was 3.9 grs. CD which produced an average of 777 FPS. which is a 178 PF.
The last load was 4.0 grs . CD which produced an average of 780 FPS  which is a 179 Pf

The interesting thing was the Claydot had a smaller spread of speed ( in fact all three loads had duplicate speeds) than Clay's

So ClayDoy can be use with Clay's data with a more consistent FPS

Nawlins

Goatneck

  • WBAS Committee & Ambassadors
  • Sr. Member
  • *******
  • Posts: 314
    • WBAS Committee & Ambassadors
Re: Clay's vs Claydot
« Reply #1 on: November 20, 2015, 07:11:52 AM »
Kid

Good info to know. the smallest amount of FPS deviation is the most desireable. See youall at the convention

Garrison Joe

  • Hero Member
  • *****
  • Posts: 764
Re: Clay's vs Claydot
« Reply #2 on: November 20, 2015, 07:36:52 AM »
Yep, those numbers are consistent with my testing and use.   I almost always find 0.1 or 0.2 extra grains of CD is needed to maintain exactly the same velocity as Clays in pistol cartridges.

You will also find that CD is not cold sensitive like Clays has been.   Haven't had a chance to test any Canadian Clays yet - all I have is Australian-produced Clays.

Good luck, GJ
Good luck, GJ

Ride hard, shoot straight and speak the truth.    Col. J Cooper
Why else would you want to be here?

60708 Life/Regulator

Nawlins Kid

  • WBAS Committee & Ambassadors
  • Full Member
  • *******
  • Posts: 155
Re: Clay's vs Claydot
« Reply #3 on: November 20, 2015, 06:08:16 PM »
At the NY State WB last April my rifle load with 200 gr. bullet with Clays was effected by the cool weather we had.  Since I never load at the minimum load I had no problem with the Clays meeting the PF.  I will now be loading  the 45 ACP with Claydot for now on.

Nawlins

docmccoy

  • Newbie
  • *
  • Posts: 1
Re: Clay's vs Claydot
« Reply #4 on: January 19, 2016, 11:05:28 AM »
Thanks Nawlins.  I won 8# of Clay Dot at Heluva Rukus and have been checking on it's use since then.  I loaded a few test rounds that I have not yet fired.  Getting around to it sometime this winter.