Author Topic: Coated Bullets: Zediker speaks  (Read 1404 times)

Grouchy Spike

  • Full Member
  • ***
  • Posts: 243
Coated Bullets: Zediker speaks
« on: February 18, 2017, 01:29:40 PM »
http://www.mssblog.com/2017/02/17/reloaders-corner-coated-bullets/

Although this article relates to shooting jacketed bullets and Boron Nitride coating, the author makes interesting comments about seasoning a barrel, as did Dusty Boddams. 

What is the composition of the Hi-Tek coating that has gained following among cast bullet shooters?
Run - Hide - Call?  Forget it !  Draw - Aim - Shoot

lostvaquero

  • Newbie
  • *
  • Posts: 40
Re: Coated Bullets: Zediker speaks
« Reply #1 on: June 14, 2017, 10:30:38 AM »
I use the Hi-Tek bullets and love them.  No I have not ever chronographed or done any other testing but the barrels take very little cleaning.  I got 230gr SNS coated round nose to load in 45ACP and some 200gr coated to load in 45 Schofiled for rifle.  I have yet to have a problem with the bullets, even used the 45s out of a semi auto Thompson without any problems. 

The only thing I have ever read is if the barrel is a bit tight, then the coating can be stripped right off and one can get leading of the barrel.  Otherwise from what I have seen there is very little residue left unlike the moly coated.

As far as CAS shooting, out of say 35 shooters probably only 3 to 5 of us had Hi Tek coated bullets.  So I do not think it has caught on as much but I also like that your lead exposure is lower than regular cast. 

Garrison Joe

  • Hero Member
  • *****
  • Posts: 764
Re: Coated Bullets: Zediker speaks
« Reply #2 on: June 14, 2017, 02:52:59 PM »
Hi-tek is a thermoplastic polymer plastic, from what I can get folks to talk about.  At least, some sort of plastic.  Which isn't all that new - S&W made nyclad bullets in the 1970s' (nylon coated)

Plastic is a long ways away from that boron nitride coating. 

Good luck, GJ
Good luck, GJ

Ride hard, shoot straight and speak the truth.    Col. J Cooper
Why else would you want to be here?

60708 Life/Regulator

August West

  • Full Member
  • ***
  • Posts: 165
Re: Coated Bullets: Zediker speaks
« Reply #3 on: June 15, 2017, 11:09:16 AM »
I recently had occasion to repair a '73 rifle where the shooter had been using polymer coated bullets for a couple of years.  There was a hard, almost ceramic-like, build up underneath the extractor.  This had gotten to the point where the extractor was no longer reliably grabbing the cartridge rim for extraction.

Now, that build up might have been from low power loads, or poor powder choice.  But, the nature of the 'gunk' was hard and solid.  Not what I've found before with black powder and lead bullets.

F.Y.I.

Happy Jack

  • Moderator
  • Hero Member
  • *****
  • Posts: 669
  • Wild Bunch Committee Chairman
Re: Coated Bullets: Zediker speaks
« Reply #4 on: June 15, 2017, 03:31:48 PM »
You may shoot what you wish, BUT, I will NOT shoot the poly coated bullets in my guns. Just the opinion of an old narrow minded chemist who has been shooting matches for over 50 years.
1911's RULE !!!

UnionJack

  • Newbie
  • *
  • Posts: 24
Re: Coated Bullets: Zediker speaks
« Reply #5 on: June 20, 2017, 08:41:17 PM »
Would you care to expound on that ? For the benefit of one who is not a chemist and has not been shooting matches for 50 years. I shoot Poly coated bullets in lots of guns with seemingly no ill effects ,at least on the surface.

August West

  • Full Member
  • ***
  • Posts: 165
Re: Coated Bullets: Zediker speaks
« Reply #6 on: June 21, 2017, 09:36:07 AM »
I shoot Poly coated bullets in lots of guns with seemingly no ill effects

Yet!

UnionJack

  • Newbie
  • *
  • Posts: 24
Re: Coated Bullets: Zediker speaks
« Reply #7 on: June 21, 2017, 09:50:27 AM »
Well maybe I just have it coming ,but it would be nice to discover some science behind opinion.

J. Frank Norfleet

  • IXL
  • WBAS Committee & Ambassadors
  • Hero Member
  • *******
  • Posts: 619
Re: Coated Bullets: Zediker speaks
« Reply #8 on: June 21, 2017, 12:50:18 PM »
I watched a YouTube video of a guy that sprayed painted his bullets with Rustoleum. LoL He said it was just as good as Poly and wouldn't harm your barrel. Not in my guns.
"Pilgrim, life is hard - It's a lot harder when you're stupid."  Marion Mitchell Morrison

"The difference between stupidity and genius is that genius has its limits." Albert Einstein